Publicidad
Idiomas disponibles
Idiomas disponibles
Service
Troubleshooting
The cooktop
is not working
,_-is flashing on the heating
element display
c will be flashing in all of the
heating element displays, and an
acoustic signal will be audible
The cooktop
has turned itself off
Repairs
If you encounter a problem, it frequently will merely be something minor. Before you
call customer service, consider the following suggestions and instructions:
Check the condition of the fuses/circuit breakers at your location. Check to see if
you are experiencing a power failure.
The touch control zone is very dirty, food has boiled over, or an object is lying on top
of the control settings zone. Thoroughly clean the touch control zone, or remove the
object lying on the zone if that may be causing the problem. Touch the touch control
zone that seems to be involved in the problem. The flashing will stop.
The main switch was operated continuously for longer than five seconds.
Thoroughly wipe off the touch control zone and remove any objects that might be
sticking to the zone. Enter your settings again.
The main switch was accidentally touched. Turn the unit on again. Enter your
settings again.
Repairs may only be performed
by trained customer service technicians.
Display E and numbers
Display F and numbers
_
ARNING:
If your unit is repaired in an unprofessional manner, you may
be exposed to substantial risks.
If an E and numbers appear in the display areas, an electronic fault has occurred.
Use the building circuit breaker or the circuit breakers in your circuit breaker box to
turn the unit off and then on again. If the display appears again, call customer
service.
If F and numbers appears in the display, your unit has detected a fault. The following
table lists actions you can take to correct the problem.
18
Publicidad
