Greencut EBV3000C Guía De Mantenimiento página 16

ASSEMBLY
STEP BY STEP
05
#1
#5
Insert the collection bag #5, into the body of the machine, noting the area designed for insertion.
Your EBV3000C is now ready!
USE OF THE PRODUCT
IMPLEMENTATION
Before starting the vacuum blower, make sure that the two intermediate suction/blowing pipes
together with the machine body are correctly mounted.
Do not attempt to pick up wet debris, or allow fallen leaves etc. to dry before using the vacuum
blower. The vacuum blower can be used to blow debris from yards, driveways, paths, lawns, shrubs
and bushes, etc., before using the vacuum blower.
paths, lawns, shrubs and borders. It will also pick up leaves, paper, small twigs and wood chips.
When using the vacuum blower in suction mode, waste is sucked through the suction tube before
being ejected into the waste collection bag, as the waste passes through the suction fan it is partially
shredded. The shredded organic shredded organic waste is ideal for use as mulch around plants.
Warning! Any hard objects, such as stones, glass cans, etc., will damage the vacuum blower.
Important: Do not use the V do not use the vacuum blower to suck up water or very wet debris.
Never use the vacuum blower without the debris collection bag fitted.
WARNING: IF THE CABLE IS DAMAGED, HAVE IT REPLACED BEFORE USING THE BLOWER.
Inspect the area to be worked on before starting. Remove any objects or debris that may be thrown,
jammed or entangled in the vacuum blower. Select the blowing function using the selector lever on
the side of the machine. With the vacuum blower resting on its wheels, move the vacuum blower
forward directing the nozzle towards the debris to be cleaned.
Alternatively, hold the nozzle just above the ground and turn the machine from side to side. Blow
the debris into a convenient pile and then use the vacuum function to collect the debris.
Remove any objects or debris that may be thrown, caught or entangled in the vacuum blower. Select
the vacuum function using the selection lever on the side of the machine and turn it on. With the
vacuum blower resting on its wheels, move the vacuum blower forward directing the nozzle towards
the debris to be picked up. Alternatively, with the vacuum blower held just above the ground, swing
the machine from side to side, moving forward and directing the nozzle towards the waste to be
collected. Do not force the nozzle towards the waste, as this will block the suction tube and reduce
the efficiency of the machine.
Organic materials, such as leaves, contain a large amount of water which can cause them to stick to
the inside of the suction tube. To reduce sticking, the material should be left for a few days to dry.
ATTENTION: WHEN UNLOADING SHREDDED LEAVES, DISCONNECT THE MAINS PLUG FROM THE
MAINS AND TURN THE SWITCH TO THE OFF POSITION.
16
EN - EBV3000C