Kärcher K 5 Classic Manual Del Usuario página 10

Accessories and spare parts
Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.
Scope of delivery
The scope of delivery for the appliance is shown on the
packaging. Check the contents for completeness when
unpacking. If any accessories are missing or in the
event of any shipping damage, please notify your deal-
er.
Device description
For the figures, please refer to the graphics page
Illustration A
Transport wheel
1
Storage for high-pressure gun
2
Storage for spray lance
3
Storage for high-pressure hose / mains connection
4
cable
Spray lance dirt grinder for stubborn soiling
5
Vario Power spray lance for common cleaning tasks
6
The working pressure can be continuously in-
creased from "SOFT" to "HARD". To adjust the
working pressure, release the trigger gun lever and
turn the spray lance to the desired position. Deter-
gent can be added to the water jet when the spray
lance is turned all the way in the SOFT direction.
High-pressure gun
7
Clamp for connecting / disconnecting the high-pres-
8
sure hose
High-pressure gun lever
9
High-pressure gun lock
10
High-pressure hose
11
Mains connection cable with mains plug
12
Trigger "0/OFF" / "I/ON"
13
Transport handle, extendable
14
High-pressure connection
15
Type plate
16
Water connection with integrated sieve
17
Detergent suction hose
18
Coupling for the water connection
19
*Garden hose (fabric reinforced, diameter at least
20
1/2 inch (13 mm), length at least 7.5 m, with com-
mercially available quick coupling)
* additionally required
10
Safety devices
CAUTION
Missing or modified safety devices!
Safety devices are provided for your own protection.
Do not bypass, remove or render ineffective any safety
devices.
The power switch prevents unintentional operation of
the device.
High-pressure gun lock
The lock locks the lever of the high-pressure gun and
prevents the device from starting unintentionally.
Auto-stop function
If the lever of the high-pressure gun is released, the
pressure switch turns off the pump and the high-pres-
sure jet stops. The pump switches on again when the le-
ver is pressed.
Symbols on the device
Do not aim the high-pressure jet may at per-
sons, animals, live electrical equipment or
the device itself.
Protect the device against frost.
The device may not be connected to the
public drinking water network.
For the figures, please refer to the graphics page.
Fit the supplied loose parts onto the device before start-
ing up the device.
Installing the water connection coupling
1. Screw the water connection coupling onto the water
connection on the device.
Illustration B
1. Place the device on a level surface.
2. Unwind the high-pressure hose and eliminate any
loops and twists.
3. Connect the high-pressure hose to the device.
a Pull up the clamp on the coupling.
b Insert the high-pressure hose into the coupling.
c Press down the clamp on the coupling.
Illustration C
4. Insert the high-pressure hose into the high-pressure
gun until it audibly clicks into place.
Note
Take care to ensure the correct alignment of the nipple.
Illustration D
5. Check for a secure connection by pulling on the
high-pressure hose.
6. Plug the mains plug into a mains socket.
Note
Take care not to exceed the maximum permissible
mains impedance at the electrical connection point (see
chapter Technical data).
Contact your electricity supplier in the case of any un-
certainties regarding the mains grid impedance at your
electrical connection point.
English
Power switch
Mounting
Initial startup