GENERATOR MAINTENANCE
Proper care will ensuremaximum performanceof your generator.
Generatormaintenanceconsists of keepingthe unit clean and dry.
Operateand store the unit in a clean dry environmentwhere it will
not be exposedto excessivedust, dirt, moisture or any corrosive
vapors.
Cooling air slots in the generatormust not become clogged with
snow, leaves,or any other foreign material.
Checkthe cleanlinessof the generatorfrequently and clean when
dust, dirt, oil, moisture or other foreign substances are visible on
its exteriorsurface.
NOTE:
Never insert any object or tool through the air cooling slots,
even if the engine is not running.
NOTE:
DO NOT use a garden hose to clean the generator. Water
can enter the engine fuel system and cause problems. In
addition, if water enters the generator through cooling air
slots,some water will be retained in voidsand crevicesof the
rotor and stator windinginsulation.Water and dirt buildup on
the generator internal windings will eventually decrease the
insulationresistanceof thesewindings.
GENERATOR MAINTENANCE
SCHEDULE
Follow the recommendedservice schedule;to order replacement
_arts call 1-888-436-3722.
FuelLevel
Oil Level
CheckAir Filter
*Change EngineOil
**Clean Air Filter
CheckSpark Plug
CheckMuffler
ReplaceSpark Plug
ReplaceFuelFilter
Each
Use
X
X
X
Every100
Hours
X
X
Every6
Each
Months
Year
X
X
X
X
* Perform initial oil changeafter the first five (5) hours of operation
** Clean the air filter more often if operating in dusty or sandy
conditions. Replaceas necessary.
CLEANING THE GENERATOR
1. Use a damp cloth to wipe exteriorsurfaces clean.
2. A soft, bristle brush may be usedto loosen caked on dirt, oil,
etc.
3. A vacuum cleaner may be used to pick up loose dirt and
debris.
4. Low pressure air (not to exceed 25 psi) may be used to
blow away dirt. Inspect cooling air slots and openings
on the generator. These openings must be kept clean and
unobstructed.
5. Inspect the vent hoses on the left side of the generator.Make
sure the hoses protrudethrough the slots below the door and
that the ends are open and free of debris.
ENGINE MAINTENANCE
,&CAUTION!
,_
Only work on a generator
that has cooled
completely.
Inspect the oil leveland air filter condition eachtime you are going
to usethe generator. T o checkthe air filter and oil levelthe left side
service cover must be removed; use a screwdriver to loosen the
screw securingthe cover and remove.
The air filter is located behind a cover for the air box (Figure 10).
Push the tab on the bottom of the air box upwards to releasethe
cover.To servicethe air cleaner:
1. Removethe air cleaner. Tapthe elementto shake loose any
large particles.
2. Wash the element in soapy water. Squeezethe filter dry in
clean cloth (DONOTTWIST).
3. Soakthe filter elementin cleanengineoil. Squeezethe excess
oil from the filter, leavinga light coating.
4. Clean air cleaner housing and cover before re-installing the
filter element.
Figure 10- Air Filter
AIR
FILTER
LEFT SIDE
SERVICE
COVER
FINER
HOUSING
COVER
LEFT SIDE
SERVICE COVER
SCREW
1o