Clatronic BS 1305 A Instrucciones De Servicio página 33

• Cleaning and user maintenance shall not be made by children
without supervision.
• The device is intended for use with safety extra-low voltage. Con-
nect only to a power supply according to the specifications on the
rating label.
• If the connection cable of this device has been damaged, it must be
replaced with a special connection cable available from the manu-
facturer or its customer service.
• Use only the mains adapter "YLS0041A-E180020" included in the
scope of deliveries.
• Do not suck in combustible substances or liquids!
• Avoid vacuuming sharp or pointed objects!
• Never vacuum without the filter installed.
Overview of the Components / Delivery Scope
Page 3
1 Basic unit
2 Charging indicator lamp
3 On / off switch on the basic unit
4 Handle on the basic unit
5 Telescopic crevice nozzle
6 Dirt collection container
7 Coarse dust filter
8 Fine dust filter
9 Suction inlet
10 Motor housing with air outlet
11 Floor nozzle with turbo brush
12 Unlock button for the basic unit
13 Unlock button for folding handle
14 Folding handle with appliance holder
15 On / off switch for device with floor nozzle
Page 4
16 Wall holder
17 Base
18 Socket for mains adapter
19 Contact pins
20 Charging contacts
Page 5
21 Locking / Unlocking for floor nozzle
22 Turbo brush
23 Locking / Unlocking for floor crevice nozzle
24 Locking / Unlocking for catch tray
BS1305A_IM_new
Not shown:
1x Mains adapter
3x Dowel
3x Bolt
Unpacking the Device
1. Remove the device from its packaging.
2. Check the delivery scope for completeness.
3. Check the device for any transport damage, in order to
prevent hazards.
NOTE:
In case of any transport damage, contact your dealer
immediately. Do not use a damaged device!
4. Remove the transport locks on the two On / off switches.
Notes on Use
• The device is especially suitable for quickly vacuuming
small amounts of dry dirt or dust.
• The device is operated via charged battery. The battery
is charged with the supplied charging station. Before that,
you must assemble the device and must hang it into the
charging station.
• The charging station can be installed on a wall.
• Direct power supply via mains adapter is not possible.
On / off Switch (3 and 15)
O Appliance off
I Appliance on
33
23.06.16