Descargar Imprimir esta página

UPPAbaby RumbleSeat Instrucciones De Montaje página 13

Ocultar thumbs Ver también para RumbleSeat:

Publicidad

EN
Europe
Keep these instructions for future reference.
IMPORTANT
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE. YOUR CHILD'S
SAFETY MAY BE AFFECTED IF YOU DON'T FOLLOW THEM.
WARNING
A CHILD'S SAFETY IS YOUR RESPONSIBILITY.
NEVER leave the child unattended.
This seat unit is not suitable for children under 6 months.
This product is suitable up to a weight of 15 kg or a height of 91.4 cm whichever
comes first.
Excessive weight may cause a hazardous unstable condition to exist.
This seat shall be used with only one child at a time.
Ensure that all the locking devices are engaged before use.
Check that the pram body or seat unit or car seat attachment devices are correctly
engaged before use.
To avoid injury ensure that the child is kept away when unfolding and folding
this product.
Always use the restraint system.
To avoid serious injury from sliding or falling out, always use the complete 5-point
harness with the crotch strap in combination with the waist belt and shoulder belts.
Accessories other than those approved by UPPAbaby should not be used.
Use only replacement parts supplied or approved by UPPAbaby.
DO NOT make any alterations or modifications to the product with parts not
supplied by the manufacturer, as this may cause instability or structural damage not
covered under warranty.
DO NOT let the child play with this product.
The brake must be locked on the pushchair while taking the child in or out of the
RumbleSeat, and when parked.
Bumper bar must be attached at all times.
DO NOT lift the product by bumper bar as it may disengage.
NEVER leave child in the product while ascending or descending stairs, or using
an escalator.
Children should not be left unattended in the product with rain shield fitted.
22
The stability of the product will be impaired in high winds with the rain shield fitted
and should be steadied by an adult at all times.
Rain shield must be removed when indoors and in hot weather to prevent
overheating and possible risk of suffocation.
This product is not suitable for running or skating.
NOTE: Intended for use only with UPPAbaby VISTA model year 2015 and later.
Throughout this document the secondary seat is referred to as the RumbleSeat and
the primary seat, which is included with the VISTA, is the main seat.
WARNING
When using the VISTA in double mode, load
the child into the upper seat before loading
the second child into the lower seat.
DO NOT have a child in the lower seat
without having a child in the upper seat.
WARNING
DO NOT allow child to stand while in the RumbleSeat.
DO NOT lean or press on the RumbleSeat with excessive force.
Always push the pushchair with both hands when using the RumbleSeat.
Pushchair can fold with adapters attached, however, the RumbleSeat must be
removed and the main seat must be facing forward in an upright position.
Before each use, inspect your RumbleSeat to make sure the brackets are fully
engaged by pushing down on the top of the RumbleSeat firmly. NOTE: It should
not move.
Manufactured to comply with: EN 1888-1
Manufactured to comply with: BS EN 1888-1
EN
Europe
23

Publicidad

loading