Publicidad
Placement
• Before use, remove all packing materials, including bottom cushions, foam
pads and tapes inside of the refrigerator; tear off the protective film on the
doors and the refrigerator body.
• Keep away from heat and avoid direct sunlight. Do not place the freezer in
moist or watery places to prevent rust or reduction of insulating effect.
• Do not spray or wash the refrigerator; do not put the refrigerator in moist
places easy to be splashed with water so as not to affect the electrical
insulation properties of the refrigerator.
EN
• The refrigerator is placed in a well-ventilated indoor place; the ground shall be
flat, and sturdy (rotate left or right to adjust the wheel for leveling if unstable).
Leveling feet
To avoid vibration, the unit must be leveled.
If required, adjust the leveling screws to compensate for the uneven floor.
The front should be slightly higher than the rear to aid in door closing.
Leveling screws can be turned easily by tipping the cabinet slightly.
Turn the leveling screws counterclockwise
lower it.
Moving the appliance
1. Remove all food from inside the appliance.
2. Pull the power plug out, insert and fix it into the power plug hook at the rear or
on top of the appliance.
3. Tape parts such as shelves and the door handle to prevent from falling off
while moving the appliance.
4. Move the appliance with more than two people carefully. When transporting
the appliance over a long distance, keep the appliance upright.
5. After installing the appliance, connect the power plug into a socket out to
switch on the appliance.
ATTENTION
Precautions before operation:
Before making changes the refrigerator must be disconnected from power. precautions
should be taken to prevent any personal injury.
to raise the unit, clockwise
09
to
Publicidad
