Vetus HATO12C Manual De Instalación Y Usuario página 12

Using a pencil, mark out the 4
fixing holes of the frame and
drill them with the correct di-
ameter.
If necessary, use washers at the
top or bottom of the frame to
ensure the frame is vertical (use
a water level).
Attach the frame to the wall. De-
pending on the surface, use the
appropriate fasteners (not sup-
plied) to do this.
Measure the pitch size (A1) of the toilet bowl.
Set the pitch size (A2) of the
frame to be equal to the pitch
size (A1) of the toilet bowl.
12
110128.11
A1
A2
Attach the threaded ends to the
frame with the nuts and lock
washers (supplied).
Note: Allow the threaded ends
to protrude 65 mm.
3.2 Electrical installation
3.2.1 12 V or 24 V system
• Check that the voltage stated on the motor's type plate matches
the on-board voltage.
• Use batteries with sufficient capacity to obtain correct operation
of the toilet.
• Connect the supply voltage as shown in the wiring diagram, see
page 43.
• Place a switch and fuse in the plus ('+') wire (25A @12V & 15A @24V)
• Apply wires with a minimum cross-section of 6 mm
4 mm 2 (for 24 V).
3.2.2 Control panel (12 V / 24 V)
• Mount the mounting flange with the gasket in the wall. For hole
dimensions, see page 41.
• Feed the cable through the flange to the toilet and connect it to
the cable on the toilet. Apply the enclosure provided over the
plug connector for protection.
• Click the panel into the mounting flange. Ensure that the gasket
is fitted correctly.
3.2.3 110 V or 230 V sytem
• Connect the power supply as shown in the wiring diagram.
• Use a double-pole switch and install a double-pole circuit breaker
(in the phase and neutral wire).
3.3 Water supply
Use copper piping or hoses for the water supply.
Provide the water supply with
a ball valve with a 3/4" external
connection.
Make sure the connection is
approximately 150 mm above
the frame and the ball valve re-
mains accessible.
Secure the supply line with
clamps.
Installation manual HATO_C electric marine toilet
65 mm
2 (for 12 V) or
G 3/4