cecotec DRUMFIT ELLIPTICAL 10000 MOTOR PRO Manual De Instrucciones página 31

ENGLISH
Data displayed by the console
No. Icon Description
1 Heart rate
Displays real-time heart rate if a pulse signal is received, otherwise
nothing is displayed.
2 Resistance level
Setting range: 1 ~ 24/32
The higher the level, the greater the resistance.
3 Scan
Scan icon on: the data displayed on the display changes every 3 seconds.
Scan icon off: Only the data that is fixed on the display is shown.
4 Speed
Range: 0.0 ~ 999.9 km/h
5 Time
Range: 00:00 ~ 99:59
The counter starts once motion is detected or the display is briefly
pressed.
The counter stops counting if more than 4 seconds pass without
detecting movement.
6 Distance
Display range: 0.0 ~ 999.9 km
7 Calories
Display range: 0.0 ~ 999.9 kcal
Displays an approximate value of calories burned, proportional to the
level of resistance:
Resistance 1 corresponds to 11.4 kcal/km, and resistance 32 to 44.6 kcal/
km.
8 Bluetooth
If this icon is shown on the display, it means that Bluetooth is connected.
If not displayed, Bluetooth is not connected.
60 DRUMFIT ELLIPTICAL 10000 MOTOR PRO
9 Setting targets
When this icon appears, you can set a data as a target for the training.
If the time icon is activated, a time target (min) can be set.
If the distance icon is activated, a distance target (km) can be set.
If the calorie icon is activated, a calorie target (Kcal) can be set.
Setting targets
- You can set target goals for the parameters Time, Distance and Calories. To do this, turn the
knob until the desired parameter is lit.
- Time setting: turn the knob clockwise, it will increase by 1 minute for each rotation and
decrease by 1 minute otherwise. The lowest target goal is 1 minute.
- Distance adjustment: turn the knob clockwise, it will increase by 0.5 km per rotation,
decrease by 0.5 km the other way round. The minimum target goal is 0.5 km.
- Setting the calorie consumption: turn the knob clockwise, it will increase by 1 kcal for each
turn, decrease by 1 kcal otherwise. The lowest target goal is 1 kcal.
- When the target goal is reached, the controller will beep three times in quick succession.
- The motion data does not return to zero until it enters the standby mode.
- Press and hold the console for 2 seconds to exit motion mode. When you exit motion
mode the display will show the target value last set. Press and hold the console again for
2 seconds to clear the target.
Data display on the console
- By default, whenever a training session is started, the console has the SCAN function
activated and displays the different parameters. One press of the button deactivates the
SCAN function and sets the training data on the display.
- If a signal is detected in the heart rate sensor, the beats per minute will be displayed at
the top of the console, right where the resistance level is indicated. The display of these
2 parameters shall alternate every 3 seconds. If no pulse signal is detected, only the
resistance level is displayed. Fig. 12
Auto switch-off: after 3 minutes of inactivity, the display switches off automatically.
Auto switch-on: if motion is detected or the console is pressed or rotated, the console turns
on automatically.
Bluetooth connection:
By scanning the QR code below you can access a manual explaining how to pair the DrumFit
Elliptical 10000 Motor Pro elliptical cross trainer with the Kinomap app:
ENGLISH
DRUMFIT ELLIPTICAL 10000 MOTOR PRO 61