Publicidad
Idiomas disponibles
Idiomas disponibles
•
Load a log onto the beam against the endplate (Max log length is 63.5cm - 25").
BAD
LOG
ATTENTION
•
If a log gets stuck, embedded or will not split completely, push the control lever in the reverse
direction and allow the splitter to strip the log from the wedge.
•
If the log remains stuck, embedded or will not split, turn the machine off and use a hammer
and crow bar to remove the log.
•
ALWAYS keep hands clear of the log and wedge while it is retracting.
•
Always keep the work area clean and free of split wood and debris.
•
Push control lever FORWARD by one hand to split the log.
•
Push control lever BACKWARD by one hand to return wedge to its original position.
MAINTENANCE
Improper maintenance and storage of the log splitter may void the warranty.
ATTENTION
•
Removal of safety devices, improper maintenance, replacement of items with non-original
spare parts may cause bodily injury.
•
Before performing maintenance, the log splitter must be placed in maintenance mode. Turn off
the engine and move the control lever forward and backwards to relieve the hydraulic pressure.
•
After performing any maintenance work, make sure all guards, shields and safety features are
put back in place before operating the log splitter.
•
Regularly grease axle and wheel bearing area or when needed.
•
After the wheel bearings have been greased make sure the axle nuts and pins are in place
and secure.
•
Periodically check that all clamps, screws and hoses are tight and not leaking.
•
Clean and lightly lubricate all moving parts or when needed.
•
Use a glossy enamel spray paint to touch up scratched or worn painted metal surfaces.
•
Never exceed load capacity rating of 22 tons, as it would damage the log splitter.
GOOD
LOG
67
BETTER
LOG
EN
Publicidad
