Speed Settings - Dremel MS20 Instrucciones De Funcionamiento Y Seguridad

DM 2610Z03287 05-13_DM 2610Z03287 05-13.qxp 5/24/13 8:09 AM Page 18
Material
Plywood
Pine
Wood Poplar
Balsa
Laminate Flooring
HVAC
TIN
Metal
AL sheet
Gal. Sheet Metal
Plexiglass
Plastic
PVC Pipe
• Three things will have great effect on the
cut when using a scroll type saw:
1. The material being cut.
2. Blade speed (strokes per minute blade).
3. Cutting speed (how fast material is
pushed into blade).
• There is not ONE blade that is the best for
every given job.
• A coarse blade should be used for thicker
material and a finer blade for thinner
material. The thinner the blade, the
sharper the turn it can execute.
• There should always be 3 to 4 teeth in
contact with the work at all times.
• Cutting hard material like metal and
material that can melt, like acrylic, will
generally require slower speed on the tool
and a lower feed rate.
• The best starting point on any cut is at a
point or corner because you can control

Speed Settings

Tool Recommended
Speed Thickness
6 .75"
6 .75"
6 .75"
6 1.75"
6 .5"
6 20-ga.
6 20-ga.
6 20-ga.
6 20-ga.
4 .2"
4 .75"
Scroll Saw/Moto-Saw Tips
• Certain actions will require practice – like
• Saws that scroll can present a challenge
• If a blade seems to be cutting slowly or
18
MS51 Wood MS52 Fine
& Plastic Wood
Blade Blade
x x
x x
x x
x x
x x
x x
x x
the intersection of the cut and make it as
smooth as it needs to be.
cutting a corner or a 180° turn.
when attempting a straight cut. With some
practice, it's easy to do. Practice
compensating for the grain by turning the
material slightly to stay on a straight line.
Once the degree of compensation is
determined for any material, being able to
then cut a straight line will only be a matter
of blade selection, speed, and feed rate.
seems to wander with little means of
control, chances are the blade is becoming
dull. There's no substitute for a sharp
blade. Wood and metal will both dull a
blade quickly. If a lot of cutting is being
completed, change your blade as often as
necessary.
MS53 MS50 Side
Metal Cutting
Blade Blade
x
x
x
x
x
x
x
x
x
x
x