Taurus MINIMOKA CM-1821 Manual Del Usuario página 11

English
Coffeemaker
CM1821
DESCRIPTION
A Water Tank Lid
B Water tank
C Hot plate for warming cups
D Connection pilot light
E Heating pilot light
F Start/Stop Switch
G Coffee outlet/Water outlet Switch
H Steam heating Switch
I Steamer pipe
J Filter holder
K Measuring spoon
L Filter for single measure (or POD???)
M Ground coffee filter (2 cups)
N Supply cable
O Drip tray
P Tray grill
Q Steam knob
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not switch the appliance on without water.
- Do not use the appliance if the on/off switch
does not work.
- Do not move the appliance while in use.
- Respect the MAX and MIN levels
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Keep this device out of reach of children and
/ or people with reduced physical, sensory
or mental abilities or lack of experience and
knowledge.
- Do not store or transport the appliance if it is
still hot.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or lo-
cked and make sure there are no broken parts
or anomalies that may prevent the appliance
from operating correctly.
- Never leave the appliance unattended while in
use.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not remove the filter holder when coffee is
being made, as at that time it is under pressure.
- Any misuse or failure to follow the instructions
for use renders the guarantee and the manu-
facturer's liability null and void.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all the product's packaging has
been removed.
- Before connecting the machine, check that
the buttons (F, G) are not pressed, and steam
control (Q) is closed
- Before using this product for the first time, it is
advisable to test it only with water.
- Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
PRIMING THE CIRCUIT:
- This simple operation ensures optimum dispen-
sing and must be carried out:
- When first starting:
- When the machine has been out of use for a
long time (1 or 2 weeks).
- After making steam.
- When the tank has run out of water.
- Fill the receptacle taking care to observe the
MAX level.
- Connect the appliance to the mains.
- Press the on/off switch (F) to ON position. The
(D) pilot light will come on.
- You do not have to wait for the machine to heat
up for this operation.
- Without fitting the filter holder (or with the filter
holder fitted, but without coffee), place a reci-
pient under the steam pipe (I)
- Open the steam knob (Q) by turning counterc-
lockwise.
- Press the coffee switch / water (G) to on
position.
- Water will exit through the steam pipe. Wait
until approximately one cupful has exited.
- To finish serving, back coffee / water switch to
OFF position and close the steam knob (Q) by
turning clockwise.