Taurus MINIMOKA CM-1821 Manual Del Usuario página 12

- This will complete the priming operation.
FILLING WITH WATER:
- The deposit must be filled with water before
turning the appliance on.
- Remove the water tank.
- Open the cover.
- Fill the deposit taking care to observe the MAX
level (Fig. 1)
- Close the lid.
- Replace the tank in its housing, ensuring that it
is well fitted.
PREPARING COFFEE:
- Before connecting the machine, check that
the buttons (F, G) are not pressed, and steam
control (Q) is closed
- Connect the appliance to the mains.
- Remove the filter holder.
- Position the ground coffee filter (M) filter holder
- We recommend using natural toast coffee, as
using roasted coffee may affect the operation
of the machine.
- Fill the removable filter with ground coffee (67
g per cup to be prepared).
- If you wish to make 1 coffee, fill the ladle (1
spoonful) and take the capacity of the measu-
ring spoon as the measure for one coffee until
half its capacity.
- For 2 coffees, put in 2 spoonfuls.
- Next lightly press down the ground coffee with
the back of the spoon.
- Before fitting the filter holder in the coffeema-
ker assembly, turn the ladleholder backwards.
- Fit the filter holder in the appliance once more.
- Position the filter holder in the coffee assem-
bly by inserting the assembly downwards and
turning it from left to right until it locks.
- Insert the filter holder with coffee into the
appliance
- Turn it anticlockwise until it is in the locked
position.
- Turn the appliance on using the on/off switch
(F)
- The (D) pilot light comes on.
- Wait until the pilot light (E) is lighting
- Place one or two preheated cups at the filter
holder outlet.
- Press the coffee switch (G) to the ON position
The coffee infusion will begin to exit. When you
have obtained the desired quantity of espresso
coffee (short or long), come back switch to OFF
position
- Once serving has finished, wait a few seconds
and remove the cups with the coffee.
- Remove the filter holder and empty the
grounds from it.
- Wash the filter holder with running water and
dry it well.
- Check that the removable filter is perfectly
fitted into the filter holder.
- Fit the filter holder in the appliance once more.
GETTING HOT WATER:
- Put The device in ON situation, pressing the
knob ON/OFF (F)
- The Heating indicator light (D) will illuminate
indicating that the water is heating up.
- Wait Until the pilot light coffee outlet (E) is also
highlighted. This situation indicates that the
water has reached the right temperature.
- Place A container under the nozzle.
- Open The steam control (Q), turning him to the
left, counterclockwise
- Press The button coffee /water outlet (G)
- The Hot water began to come out of the vapo-
rizer.
- 'Once obtained the desired amount of hot wa-
ter, press the coffee outlet button, which stops
the pump
- Close The turning knob (Q) to the right, clock-
wise
OBTAINING STEAM:
- The steam is used to foam milk for cappuccino,
and also to heat other liquids.
- Turn the appliance on using the on/off switch.
- Wait until the pilot light has gone out which
will indicate that the appliance has reached an
adequate temperature.
- Press the heating button and continue heating
until the steam temperature has been reached.
- the Warning light (E) will illuminate indicating
that the water has reached the necessary
temperature for generating steam.