Würth 0772 800 100 Traducción Del Manual De Instrucciones De Servicio Original página 21

BAD CELL & REPLACE
××.××V ×××× SAE
LOAD ERROR
PRINT RESULT?
◄ ► ↵
NO
PRINT 24V SYSTEM
RESULT?
YES
BAD CELL & REPLACE
The battery has at least one cell short circuit. It should be replaced immediately.
LOAD ERROR
The tested battery is bigger than 2000 CCA or 200 AH. Or the clamps are not
connected properly. Please charge the battery completely and test it again after
both options could be excluded. If the same test result is shown, replace the
battery immediately.
Press the ◄ / ► key to select whether the result is to be printed:
Yes or No.
Confirm with Enter.
* Printing the 24V system test: The printer will not print the result of the 24 Volt
batteries system test. The 24V system test result will be recorded till you connect
a 12V battery. Then the screen on the left is displayed. Select Yes and press
the Enter key to print the result. Then disconnect the terminals. The screen
will appear again after you reconnect the terminals. Select No and press the
Enter key to return to the main menu.
Press the Enter key to get to the initial battery test menu or remove the test
terminals from the battery to switch off the device.
21