Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
160992A2T7 GCB10-5.qxp_GCB10-5 10/12/16 8:09 AM Page 12
3. Place the material guide against the
workpiece and lower the moving saw blade
into the cut.
4. Do not apply pressure when cutting. The
weight of the tool will supply adequate
pressure for the fastest cutting.
5. When completing a cut, hold the tool firmly
so it will not fall against the workpiece.
Storage
When storing the tool for a long period of
time, turn the blade tension lock lever 180°
clockwise to release blade tension (Fig. 2,
Chapter "REMOVING BLADE"). This will
extend the life of the blade.
When returning the saw to operating mode,
remember to turn blade tension lock lever
180° counter-clockwise to tighten the blade
on the pulleys (Fig. 2). Open the cover plate
to inspect and make sure that the blade lies
freely within the blade track before starting
the saw. Close the cover plate (Fig. 3). See
chapter "INSTALLING BLADE" for more
information.
Preventive maintenance performed by un -
au thorized personnel may result in
misplacing of internal wires and
components which could cause serious
hazard. We recom mend that all tool service
be performed by a Bosch Factory Service
Center or Authorized Bosch Service Station.
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
higher the cord capacity.
12
Maintenance
Service
NO USER SERVICE -
ABLE PARTS INSIDE.
Extension Cords
If an extension cord is
necessary, a cord with
FIG. 12
CORRECT
SERVICEMEN: Disconnect tool and/or
charger from power source before servicing.
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready for use
Cleaning
To avoid accidents,
always disconnect the
tool and/or charger from the power supply
before cleaning. The tool may be cleaned
most effectively with compressed dry air.
Always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
Certain cleaning agents
and solvents damage
plastic parts. Some of these are: gasoline,
car bon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Ampere
Cord Length in Feet
Rating
25
50
100
18
16
16
18
16
14
3-6
18
16
14
6-8
16
16
14
8-10
14
12
–
10-12
12-16
INCORRECT
Wire Sizes in mm
2
Cord Length in Meters
15
30
60
120
150
14
0.75
0.75
1.5
2.5
12
0.75
1.0
2.5
4.0
12
0.75
1.0
2.5
4.0
12
1.0
2.5
4.0
–
–
–
–
–
–
Publicidad
Tabla de contenido
