Clarke FOCUS II Micro Rider Instrucciones De Uso página 15

Battery type setting
Set the function electronic board of the machine and the battery charger according to the type of batteries installed (WET or GEL/
AGM) as shown below:
Turn the ignition key (58) to "I" and, in the very first seconds of machine operation, detect the current setting by counting the
5.
number of flashes of the battery warning lights (62), as shown in the following table:
SETTING DISPLAY (71)
1
2
3
4
5
6
6. If the setting is to be changed, perform the following procedure.
7. Turn off the machine by turning the ignition key (58) to "0".
8. Press and hold the switches (63) and (65) at the same time, then turn the ignition key (58) to "I".
9. Release the switches (63) and (65) within 5 seconds
10. Within 3 seconds, press the switch (65) to go to the next setting (1 to 6 in sequence).
NOTE
When performing steps 9 and 10, the settings are shown on the display (71) according to the code in the above table.
NOTE
When using batteries with a capacity lower than 160Ah@5h (if in doubt, refer to the battery documents). To avoid battery
overheating during charging procedure, use the REDUCED charging current with setting 4, 5 or 6 shown in the table,
based on the type of batteries installed.
NOTE
The battery charger must be set according to the type of batteries.
Battery charging
11. Charge the batteries (see the procedure in Maintenance chapter).
Operator's Manual - FOCUS II Micro Rider
BATTERY WARNING LIGHT INDICATION
(62)
4 flashes of the red warning light
4 flashes of the green warning light
4 flashes of the yellow warning light
2 flashes of the red warning light
2 flashes of the green warning light
2 flashes of the yellow warning light
of starting the machine.
BATTERY TYPE CHARGING CURRENT
WET
GEL-AGM STANDARD
GEL EXIDE ® type
WET
GEL-AGM REDUCED (see note)
®
GEL EXIDE type
ENGLISH
13