Before Machine Start-Up - Clarke FOCUS II Micro Rider Instrucciones De Uso

ENGLISH

BEFORE MACHINE START-UP

WARNING!
At every machine start-up, check that, between the deck (5, 10 and 28) and the machine or between the
squeegee (30) and the machine, there is no foreign material which may prevent the deck and the squeegee from
lifting. This check is necessary because, if the machine has been turned off without lifting the deck and the
squeegee, the deck and the squeegee will lift automatically at next machine start-up.
Pad-holder installation/removal (for FOCUS II MICRO RIDER 26D)
According to the kind of cleaning to be performed, the machine can be equipped either with brushes (A, Fig. 1) or pad-holders (B)
with pads (C).
For the installation/removal, proceed as follows.
WARNING!
Before turning on the switch (63), always check that between the deck (10) and the machine there is no foreign
material which may prevent the deck from lifting.
1. Lift the deck by pressing the switch (63).
2. Turn the ignition key (58) to "0".
3. Manually move the deck assembly to the left, then release the lever (D) and disassemble the covers (E) and (F) from the deck.
4. Install the brushes/pad-holders on the deck drive hub (G) by pushing them upwards until they are engaged.
To remove the brushes/pad-holders perform steps 1 to 3, then release them from the hub by pushing firmly downwards.
5.
WARNING!
If the machine is not perfectly assembled it can cause damage to people and property. Always check that all
components are assembled before starting the machine. Carefully inspect the machine before using it.
B
C
14
E
A
Figure 1
G
B
C
Front
Operator's Manual - FOCUS II Micro Rider
D
F
A
P100435