Clarke FOCUS II Micro Rider Instrucciones De Uso página 6

ENGLISH
WARNING!
Carefully read all the instructions before performing any maintenance/repair procedure.
–
Before using the battery charger, ensure that frequency and voltage values, indicated on the machine serial
–
number plate, match the electrical mains voltage.
– Do not pull or carry the machine by the battery charger cable and never use the battery charger cable as
a handle. Do not close a door on the battery charger cable, or pull the battery charger cable around sharp
edges or corners. Do not run the machine on the battery charger cable.
– Keep the battery charger cable away from heated surfaces.
– Do not use the machine if the battery charger cable or plug is damaged. If the machine is not working as it
should, has been damaged, left outdoors or dropped into water, return it to the Service Center.
To reduce the risk of fire, electric shock, or injury, do not leave the machine unattended when it is plugged
–
in. Before performing any maintenance procedure, disconnect the battery charger cable from the electrical
mains.
– Do not smoke while charging the batteries.
– To avoid any unauthorized use of the machine, remove the ignition key.
– Do not leave the machine unattended without being sure that it cannot move independently.
– Always protect the machine against the sun, rain and bad weather, both under operation and inactivity
condition. Store the machine indoors, in a dry place: This machine must be used in dry conditions, it must
not be used or kept outdoors in wet conditions.
Before using the machine, close all doors and/or covers as shown in the User Manual.
–
– Do not allow to be used as a toy. Close attention is necessary when used near children.
Use only as shown in this Manual. Use only Clarke's recommended accessories.
–
– Take all necessary precautions to prevent hair, jewerly and loose clothes from being caught by the machine
moving parts.
– Do not use the machine on incline.
– Do not tilt the machine more than the angle indicated on the machine itself, in order to prevent instability.
– Do not use the machine in particularly dusty areas.
Use the machine only where proper lighting is provided.
–
– If the machine is to be used where there are other people besides the operator, it is necessary to install the
pivoting light (optional).
– While using this machine, take care not to cause damage to people or objects.
– Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
Do not put any can containing fluids on the machine.
–
– The machine operating temperature must be between +32°F and 104°F (0°C and +40°C).
– The machine storage temperature must be between +32°F and 104°F (0°C and +40°C).
– The humidity must be between 30% and 95%.
When using floor cleaning detergents, follow the instructions on the labels of the detergent bottles.
–
To handle floor cleaning detergents, wear suitable gloves and protections.
–
– Do not use the machine as a means of transport.
Do not allow the brushes to operate while the machine is stationary to avoid damaging the floor.
–
In case of fire, use a powder fire extinguisher, not a water one.
–
– Do not tamper with the machine safety guards and follow the ordinary maintenance instructions
scrupulously.
– Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged.
Always keep the openings free from dust, hairs and any other foreign material which could reduce the air
flow.
Do not remove or modify the plates affixed to the machine.
–
– To manually move the machine, the electromagnetic brake must be disengaged. When the operation is over,
the electromagnetic brake must be activated again. Do not use the machine when the electromagnetic brake
handwheel is screwed down.
– If the machine must be pushed for service reasons (missing batteries, discharged batteries, etc.) do not
exceed 2.5 mph (4 km/h).
– This machine cannot be used on roads or public streets.
4
Operator's Manual - FOCUS II Micro Rider