Toto TES201AB Serie Manual De Instalación Y Del Propietario página 11

REFILLING THE TANK
Please refill the tank with liquid soap when the internal sensor lamp (red) starts blinking.
1. Remove the cap on the tank.
Sensor parts
Sensor
Sensor lamp
(red)
2. Slowly pour the liquid soap into the holding
tank.
Please keep an eye on the level as you
pour the liquid soap in slowly so that it
doesn't become foamy. Please pour the
liquid soap through the built-in filter.
3. Firmly close the cap on the tank.
Please make sure that the cap is securely
in place after filling the tank.
Filling the Sub-Tank (Only if a sub-tank has been installed.)
When a sub-tank has been installed, please fill
the liquid soap from the opening in the sub-tank.
Note
Pour soap slowly to avoid bubbles in the tank.
If the soap is very slow to drain into the
tank where excessive bubbling occurs,
please clean the filter and cap area.
Sensor
Open
Close
Filter
20
MODE ADJUSTMENT
Setting the Dispensing Volume of Liquid Soap
The dispensing volume of liquid soap has been adjusted to 0.04 o.z before shipping from the factory.
This volume can be changed to 0.06 o.z by pulling out the connector.
1. Remove the controller cover.
2. Remove the connector cord from the hook.
3. Pull out the connector.
4. Hang the connector on the hook.
(To prevent loss)
5. Mount the controller cover.
Caution
Tighten the screws securely.
If water is splashed over the tank, the water can
penetrate into the controller and cause damage.
Note
If the connector is connected again, the liquid
soap dispense volume is reset to 0.04 o.z.
Screw
Controller cover
Screwdriver
Connector
Hook
Connector
Screw
Pay attention not to
pinch the cord.
Controller cover
Screwdriver
21