Toto TES201AB Serie Manual De Instalación Y Del Propietario página 12

CARE AND CLEANING
For Light Cleaning
Please use a cloth that has been soaked in water
and wipe away any debris adhering to the
dispenser or sensor.
For Heavy-Duty Cleaning
After wiping away debris with a cloth containing a
suitable amount of a neutral, dishwashing
detergent, wipe clean with a damp cloth.
When cleaning around the sensor, please be
careful not to scratch the surface of the sensor.
Please avoid using cleansers that might scratch
the surface of dispenser.
These include:
Detergents containing acid, chlorine bleach or
alkali.
Solvents like paint thinner or benzene.
Detergents with coarse granules, polishing
powder or cleanser. Nylon scrubbers, pot
scrubbers, brushes, etc.
Sensor parts
Sensor
Sensor lamp
(red)
Sensor surface
Dispenser spout
22
PERIODIC MAINTENANCE - Nozzle
[ For the TLK0700*G model ]
Clean the nozzle periodically as the soap cannot flow if the nozzle is clogged.
1. Unplug from the power outlet.
2. Use the hex key included to gently loosen
and remove the screw.
(Roughly 7 turns of the hex key.)
Caution
If you clean the nozzle in a sink, make sure to
cover the drain to prevent losing the small parts.
3. Pull out and remove the nozzle after
loosening the screw.
4. Pinch the filter and pull it out from the nozzle.
5. Leave the nozzle and the filter to soak in hot
water for a few minutes.
Note
This makes it easier to remove any soap that
has adhered to the nozzle.
Nozzle
Screw
Loosen
Hex key
Make sure to fully insert the hex key
before loosening the screw. If the hex key
is not properly inserted, the screw socket
may be deformed and become unusable.
Gently pull upwards at
a slant
Remove
Filter
23