Shroud; Cleaning The Air Filter - Stihl MS 261 C-M Manual De Instrucciones

English
Picco 3/8" P 0.20" (5.0 mm)
Rapid 3/8"; 0.325" 0.24" (6.0 mm)
Rapid 0.404" 0.28" (7.0 mm)
If groove depth is less than specified:
Replace the guide bar.
N
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
42

Shroud

Removing the Shroud
To switch off the engine, move the
N
Master Control lever in the direction
of STOP or † – when released, the
Master Control lever springs back to
the run position F.
Push the hand guard forward – the
N
chain is locked.
2
1
Open the twist locks (1) by turning
N
them 1/4 turn counterclockwise with
the combination wrench.
Remove the shroud (2).
N
Installing the Shroud
Place the shroud in position.
N
Close the twist locks by turning
N
them a 1/4 turn clockwise.

Cleaning the Air Filter

If There is a Noticeable Loss of Engine
Power
Remove the shroud – see "Shroud".
N
Removing the Air Filter
Clean away loose dirt from around
N
the filter.
NOTICE
1
To avoid damaging the filter, do not use
tools to remove or install the air filter.
1.
1
2.
Rotate the air filter a 1/4 turn
N
counterclockwise and lift it away in
the direction of the rear handle.
Always replace damaged filters.
N
Cleaning the Air Filter
Knock out the filter.
N
Spray outside of filter with STIHL
N
special cleaner or soapy water.
Rinse outside of filter under warm
N
running water.
MS 261 C-M