Shroud; Cleaning The Air Filter - Stihl MS 241 C-M Manual De Instrucciones

English

Shroud

Removing the shroud
Move the Master Control lever to the
N
stop position (0).
Push the hand guard forward – the
N
chain is locked.
2
1
Open the twist locks (1) by turning
N
them 1/4 turn counterclockwise with
the combination wrench.
Remove the shroud (2).
N
Installing the shroud
Place the shroud in position.
N
Close the twist locks by turning
N
them a 1/4 turn clockwise.
42

Cleaning the Air Filter

If there is a noticeable loss of engine
power
Remove the shroud – see "Shroud"
N
Removing the air filter
Clean away loose dirt from around
N
the filter
1
NOTICE
Do not use tools to remove and install
the air filter – the air filter could be
damaged in the process.
1
1.
2.
Turn air filter 1/4 turn
N
counterclockwise and remove in the
direction of the rear handle
Always replace a damaged filter
N
Cleaning the air filter
Wash the filter in STIHL special-
N
purpose cleaner (special
accessory) or a clean, non-
flammable cleaning liquid (e. g.,
warm soapy water) – rinse the filter
from inside to out under a water jet
– do not use high-pressure cleaners
Dry all filter parts – do not expose to
N
extreme heat
Do not oil the filter
N
Reinstall filter
N
Installing the air filter
1.
2.
Fit air filter
N
Press the air filter in the direction of
N
the filter housing and
simultaneously turn it clockwise
until the air filter engages – the
"STIHL" logo must be horizontal
Fit the shroud – see "Shroud"
N
MS 241 C-M