5. SETTINGS
5.1 Setting of minimum power
☞
ATTENTION: The following regulations must be carried out only when a gas type
different from the one indicated on the data plate is utilized and after having
carried out the conversions indicated in chapter 4 above. .
• To set the minimum power, change the calibrated gas valve by-pass that determines the mi-
nimum flow-rate. .
Replacement of minimum BY-PASS
• Remove the control panel as indicated in item 3.3. above.
• Replace the by-pass as according to hte table below:
G20 (natrural gas) G30 (butane)
135
N.B.: the BY-PASS must be throughly tigtened.
• Seal the by-pass with lacquer.
5.2 Final operations
• Take the extra nameplate for the country
in which the appliance is to be installed
(A) and fit it as shown in the diagram (B).
Extra nameplate
• If the gas to be used is the same as
that used by the manufacturer when
the appliance was tested, apply the
self-adhesive surround (supplied with
the appliance) to the data nameplate
around the data for the gas concerned (C) , then
remove the nameplate fitted to the appliance by the
manufacturer to the identify the gas used for testing (D).
ATTENTION: if the gas to be used is different from that used by the ma-
nufacturer when the appliance was tested, first carry out the conversion
procedure described in chapters 4 and 5, and then apply the self-adhe-
sive surround to the data nameplate aroubd the data for the gas to
which the appliance has been converted (C). Then remove the testing
gas nameplate (D).
NATURAL GAS AND L.P.G.
G31 (propane)
85
85
xxxx
3
G 0
k
m
h
3
G 5
k
m
h
G30
k
g h
Data plate
A
xxxxxxxxxx
94
xxxxxxx
51
xxxxxx
G31
mbar
k
g h
mbar
mbar
mbar
Type
xxxxxxxxxx
xxxx
xxxxxxx
xxxxxx
3
G 0
G31
k
m
h
mbar
3
G 5
k
m
h
mbar
G30
k
g h
mbar
- 5 -
IT - ES - PT - GB - IE - GR -
ollaudato a
G S
mbar
rif. xxx x
Tested to operate with
ssay pour
Gepr ft f r
G 0
0
reparado para
r vet til drift med
Testad f r drift med
n. xxxxxxxx
Tested for drift med
Testing gas plate
94
51
k
g h
mbar
Type
C
D
B
rif. E xxx x
E n. xxxxxxxx