Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Bracket Mounting
Typical installation is shown. It may be necessary to repair the wall
after mounting. The fixture may not cover all of the wall modifications.
Mounting height per structural rough-in dimensions.
30½"
(775)
Bradley • 215-1902 Rev. C: ECO 20-08-028B
12¼" (311)
13¹⁄₈"
(333)
28" (711)
Finished Floor
Install the remaining trap cover brackets at the
C
locations defined by the horizontal line draw in
Step B and marked at 28" both to the left and right
of the center bracket. Secure the brackets to the wall
anchors using fasteners per the structural rough-in
requirement (supplied by installer) (3x).
12¼" (311)
Locating Notch
Measure down using the center location
B
notch on the wall bracket. Draw a
horizontal line and mark 28" locations to
the right and left of the center bracket.
28" (711)
Locating Notch
Install wall bracket to wall
A
per structural rough-in
dimensions. Check to
ensure the bracket is
level. Example anchor
locations shown.
1/21/2021
GLX-3 / TLX-3
(mm)
21
Publicidad
