Technical Data - Milwaukee V 28 IW Instrucciones De Uso

TECHNICAL DATA

Tool reception ..........................................................................
Torque .....................................................................................
No-load speed .........................................................................
Impact range ...........................................................................
Battery voltage ........................................................................
Weight with battery ..................................................................
Typical weighted acceleration in the hand-arm area ...............
Typical A-weighted sound levels:
Sound pressure level (K = 3 dB(A)) .......................................
Sound power level (K = 3 dB(A)) ............................................
Measured values determined according to EN 60 745.
SAFETY INSTRUCTIONS
Please pay attention to the safety instructions in the
attached leaflet!
Wear ear protectors. Exposure to noise can cause hearing
loss.
When working in walls ceiling, or floor, take care to avoid
electric cables and gas or waterpipes.
Remove the battery pack before starting any work on the
machine.
Do not dispose of used battery packs in the household
refuse or by burning them. Milwaukee Distributors offer to
retrieve old batteries to protect our environment.
Do not store the battery pack together with metal objects
(short circuit risk).
Use only V28 chargers for charging V28 battery packs. Do
not use battery packs from other systems.
No metal parts must be allowed to enter the battery section
of the charger (short circuit risk).
Never break open battery packs and chargers and store
only in dry rooms. Keep dry at all times.
Battery acid may leak from damaged batteries under
extreme load or extreme temperatures. In case of contact
with battery acid wash it off immediately with soap and
water. In case of eye contact rinse thoroughly for at least 10
minutes and immediately seek medical attention.
SPECIFIED CONDITIONS OF USE
The cordless impact wrench can be used to tighten and
loosen nuts and bolts wherever no mains connection is
available.
Do not use this product in any other way as stated for
normal use.
BATTERIES
Please take note of the specific information relating to
Milwaukee 28V rechargeable batteries in the instruction
manual for the charger.
Charge new battery packs before using.
Temperatures in excess of 50°C (120°F) reduce the
performance of the battery pack. Avoid extended exposure
to heat or sunshine (risk of overheating).
Battery packs which have not been used for some time
should be recharged before use.
The contacts of chargers and battery packs must be kept
clean.
5 ENGLISH
..................... 1/2" (13 mm)
.........................440 Nm
....................0-1450 min
-1
....................0-2450 min
-1
...........................28 V
..........................4,1 kg
.............................8 m/s
2
.........................100 dB(A)
......................... 111 dB(A)
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is
in conformity with the following standards or standardized
documents. EN 60745, EN 55014-1, EN 55014-2, in
accordance with the regulations 98/37/EEC, 89/336/EEC
Manager Product Development
MAINTENANCE
The ventilation slots of the machine must be kept clear at all
times.
Use only Milwaukee accessories and Milwaukee spare
parts. Should components need to be replaced which have
not been described, please contact one of our Milwaukee
service agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered.
Please state the Article No. as well as the machine type
printed on the label and order the drawing at your local
service agents or directly at: Milwaukee Electric Tool,
Max-Eyth-Straße 10, D-71364 Winnenden, Germany.
SYMBOLS
Remove the battery pack before starting
any work on the machine.
Do not dispose of electric tools together with
household waste material! In observance of
European Directive 2002/96/EC on waste
electrical and electronic equipment and its
implementation in accordance with national
law, electric tools that have reached the end
of their life must be collected separately and
returned to an environmentally compatible
recycling facility.
Volker Siegle