Publicidad
Idiomas disponibles
Idiomas disponibles
Switch trigger and brake lever
CAUTION:
Before installing the battery car-
tridge into the machine, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the machine, pull the switch trigger. Using the
switch trigger, the speed can be adjusted within the set
speed range. To stop the machine, release the switch
trigger and pull the brake lever.
To lock the brake lever, pull and hold the brake lever,
then pull the lock lever, and then release the brake lever
while pulling the lock lever. To release the lock, pull the
brake lever.
1
Fig.15
► 1. Switch trigger
2
Fig.16
► 1. Brake lever 2. Lock lever
Up-and-down switch
CAUTION:
Be sure to hold the brake lever
when you operate the up-and-down switch.
CAUTION:
Before using the up-and-down
switch, make sure that the remaining battery
capacity is not low. If the battery capacity is low,
lock the brake lever, and then switch the battery
cartridges to charged ones or replace the battery
cartridges with charged ones.
Fig.17
► 1. Up-and-down switch
You can lift and lower the position of the carrier using
the up-and-down switch. To lift the carrier, press the
upper side of the up-and-down switch while holding the
brake lever. To lower the carrier, press the lower side of
the up-and-down switch while holding the brake lever.
NOTE: The beep sound is emitted while the carrier
is moving.
Using the guard frames
CAUTION:
be sure to return them to their original positions
completely.
When loading or unloading the objects on the carrier,
you can lower the guard frames of the carrier by slightly
lifting up and sliding the guard frames as shown in the
1
figure.
Fig.18
► 1. Guard frame
15 ENGLISH
When raising the guard frames,
1
1
Publicidad
