Descargar Imprimir esta página

Beurer MG 99 Instrucciones De Uso página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

Attachment Heads
Ball Head
For treating large areas and large muscle groups
Bullet Head
For treating deep muscle tissue and for targeted spot massages, such as the soles
of your feet
Fork Head
For treating deep muscle tissue in the lower back area (excluding the spine) and
Achilles tendons
Flat head
For massaging large areas of the body
5. To Set Up
Before using the Mini Massage Gun for the first time, charge it first for a minimum of 3 ½ hours. To do so,
proceed as follows:
1. Remove the Massager and all attachments from the packaging.
2. Check the massager, power adapter, and attachment heads for
damage.
3. Ensure device is switched off and then attach the AC Adapter to
the jack on the bottom of the handle. Plug the AC Adapter into a
standard 100 - 240 VAC electrical outlet.
4. Route the power cord safely so that there is no risk of anyone
tripping over it.
5. During charging, the battery charge level is indicated by the
applicable LED; the left LED indicates a charge level up to 30%,
the middle LED indicates a charge level of 30-70%, and the
rightmost LED indicates a charge level of 70-99%. When 100%
charged, all three LEDs will illuminate steadily. A full charge will
last about four hours. Charge the Massager again when the left
LED flashes.
NOTE: Please note you can't use the device while charging
6. To Use
Massage treatment should feel pleasant at all times. Some redness underneath the skin may occur,
which is a positive therapeutic effect; deep tissue massage can increase blood flow in treated areas. In
rare instances, areas of redness may also occur on the skin. If you experience excessive skin irritation,
stop using the Mini Massage Gun and consult a doctor. Depending on how tense/tight your muscles are,
we recommend using the device for approx. 10 minutes on the area you wish to treat (legs, shoulders,
arms and back).
6

Publicidad

loading