Beurer MG 99 Instrucciones De Uso página 7

Choosing an Attachment
Refer to the "Parts and Controls" section to select an appropriate
Attachment Head. If a different Attachment Head is already in place
on the Massager, pull it straight out of the socket to remove. Press
the selected Attachment Head firmly onto the Massager until it clicks
into place. Be sure to replace the attachment head only when the
gun is turned off.
1. Slide the Power Switch to the "ON" position. The battery level
indicator will illuminate.
2. Press the Power Button once to activate the massager. The
intensity level display will illuminate and the massager will start
at intensity level 1.
3. To increase intensity levels, press the Power Button. If the
Massager is on the highest setting, pressing the Power Button
again will shut the Massager off.
4. To shut the Massager off at anytime, press and hold the Power Button for about two seconds. The
Battery Level Indicator and massager will shut off.
5. This device has an auto shut off feature, which will shut the massager off after 10 minutes of use.To
reactivate, press and hold the Power Button after allowing the massager to cool for at least 15 minutes.
CAUTION: Stop the massage or change the position of the massage device if you find it is painful or
unpleasant.
NOTE: Do not use the massage device right before going to bed. The massage can have an invigorating
effect and may cause difficulties in falling asleep.
Usage Examples
• Legs
7