DeWalt DCCS620 Manual De Instrucciones página 46

ENglIsh
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Accessories

WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
e
product, use of such accessories with this tool could
be hazardous. To reduce the risk of injury, only
D WALT‑recommended accessories should be used
e
with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.

WARNING: The use of accessories not recommended
in this manual may be hazardous.
Replacement chain and bar are available from your nearest
D WALT authorized service center. For use only with low kick
e
back bar and chain.
Available bars and chains for DCCs620:
Bar: service part number N594322
Chain: service part number N580237
Repairs
The charger and battery pack are not serviceable.

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by a
D WALT factory service center or a D
e
service center. Always use identical replacement parts.
44
WALT‑authorized
e
SPECIFICATIONS
DCCS620
Guide Bar
Pitch
Drive Link Gauge
Number of Drive Links
Aggressiveness
Recommended File Angle
Recommended File Size Round‑Shaped
20V Max*
12" (30 cm)
3/8" LP
0.043" (1.1 mm)
34
Low Kickback
30°
5/32" (4.0 mm)
(not included)