Reiner 880 Manual De Instrucciones página 62

REINER 880
1.4. Positioning the paper stop
Position the paper stop
4
Paper stops are used as horizontal positioning aids for print media. Paper stops
attached to the trigger table
On the hood
of the print.
The correct position of the paper stops
direction in which the print media are to be supplied to the device.
Apply the paper stops
f
1.5. Positioning and Connecting the Trip Switch
The print action can be activated by toughing the button at the trip switch
print medium or light pressure on the trigger table
Positioning and Connecting the Trip Switch
The trip switch may be attached to the trigger table
Loosen latch
f
Position trip switch
f
position.
Put on the trip switch flat to attach
f
trip switch in an opening at the trigger table or the swivel rail
it by 90°.
Connect the trigger cable of the trip to the connection socket
f
1.6. Positioning the paper holder
Paper holders
without triggering printing. There are paper holders in three lengths.
Position the paper holder
Loosen the paper holder from the accessories
f
Apply the paper holder
f
compression.
62
A
 Fig. +
5
and the swivel rail
2
and the sides of the hood, there are marks
4
so that they flank the print media.
20
from the accessory holder.
21
so that the print media tough the button in the desired print
22
prevent that print media are pushed beyond the trip switch
Fig.

22
at the receptacle of the trip switch
B F
+
15
.
4
results from the format of the print media and the
5
Fig.

5
and the swivel rail
21
it. Insert the latch
F
22
at the desired length.
3
that symbolise the position
(see "Trigger", page 83).
A + B + F
15
.
20
through the receptacle to the
15
and fasten it by turning
14
.
21
and latch by strong
4
may be
21
with the
21