Reiner 880 Manual De Instrucciones página 91

REINER 880
3.3. Replacing the Print Plate
Changing the print plate cassette
2
Grasp hood with both hands and slightly push down the triangular marks with both
f
3
thumbs .
2
Remove hood and put it aside.
f
Remove ribbon cassette
f
Pull out print plate
f
Push in new print plate
f
Apply ribbon cassette
f
the housing.
2
Push hood onto the device.
f
3.4. Cleaning Device
3.4.1. Cleaning housing
CAUTION
Electric shock when liquids enter into the device inside.
When foreign bodies have entered the inside of the device, pull the mains unit from the
f
socket and inform the specialist vendor or the REINER service.
NOTICE
Cleaning agents that are too aggressive may damage the housing surface.
Do not use any abrasives and plastic-dissolving cleaning agents for cleaning.
f
Clean the top cover of the device with a soft cloth if required. For stronger contamination,
f
moisten the cloth with water and mild detergent.
Fig.

17
at the ribbed, gripping bar marked green.
7
by the handle.
7
by the handle to the stop.
17
and push it along the guide until it latches and is tight against
B + C + E
GB
91