| AL-E77BK
m™ Suspending procedure
After the ''Fixing of Tonearm Section'' is finished, move the
tonearm about 10 mm to the center once and move back
it, then tighten screw @) (so that the tension of cord is
stabilized with the spring).
Thread the cord pulled out @ around the worm wheel.
Wind the cord
about 2.5 times.
m Fixing of Tonearm Section
Puil out the cord (1).
Fig. 12
3mm.
2. In this condition,
thread
the cord under
the plastic
washer.
Gap: approx.
3 mm
Tonearm pivot section
Mechanism base
Tonearm shaft
Plastic washer
Fig. 13
(No 2896)
1-11