Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Move the On/Auto/Off
lever
to "On/Auto"
position. The
compressor wilI start.
5.
Run the compressor for 15
minutes. Make sure the drain
valve is open and there is
minimal air pressure build-up in
tank.
6.
After 15 minutes, close the drain
valve (clockwise). The air receiver
wilI fill to "cut-out"
pressure and
the motor wilI stop.
The compressor is now ready for use.
Before
Each
Start-Up:
1.
Place On/Auto/Off
lever to "Off".
2.
PulI regulator knob out, turn
counterclockwise
until it stops.
Push knob in to lock in place.
3.
Attach hose and accessories.
NOTE: The hose or accessory
wilI require a quick connect ptug
if the air outlet is equipped with a
quick connect.
Bow
to Start:
1.
Turn the On/Auto/Off
lever
to "On/Auto" and allow tank
pressure to build.
Motor will
stop when tank pressure reaches
"cut-out"
pressure.
2.
PulI the regulator knob out
and turn clockwise to increase
pressure. When the desired
pressure is reached push knob in
to Iock in place. The compressor
is ready for use.
NOTE: Always operate the air
compressor
in welI-ventilated
areas
free of gasoline or other combustible
vapors. If the compressor
is being
used to operate a sprayer DO NOT
place near the spray area.
pressure causes a hazardous
risk of
bursting, Check the manufacturer's
maximum
pressure rating for air
tools and accessories,
The regumator
out_et pressure
must never exceed
the maximum
pressure rating,
15-ENG
A09707
Publicidad
