Programming Time Functions; Setting The Time Of Day; Setting The Minute Minder; Tone Buzzer Setting - Fulgor Milano Accento Pro 30 Serie Manual De Uso Y Cuidado

Programming time functions

At every power-up, the control shows the time of day blinking,
set at 12:00AM as the initial value, and the buzzer will sound
3 times. The time increases every minute. The only possible
action is the "Clock Regulation", all other oven operations are
inhibited.
In general, turn the Temp/Time selector left or right in order to
edit the values and modify them by steps; hold the knob on the
left or right to fasten the decrease/increase operations.

Setting the time of day

The time of day is always displayed in the 12:00 AM/PM
hours as default. Hours and minutes are set separately. In order
to set the time of day, mode selector must be in OFF position,
the -/+ knob acts on the time of day by default.
• Turn the selector left/right, the hours flash.
• Modify the flashing hours value turning the selector left/
right.
• Push the Temp&Time selector to switch back and forth
between hours and minutes.
• Modify the flashing minutes turning left/right.
• After a few seconds the whole time of day value starts
flashing: wait until the new time of day is steady.
Push the knob to toggle between the time of day and the
minute minder and check the set values. The clock is selected
by default while the symbol appears when the minute
minder is displayed.

Setting the minute minder

When the symbol is displayed, turn the knob left/right in
order to set the timer value.
The standard value is 30 minutes, it's possible to modify it in
the range between 0 and 240 minutes.
This timer has no influence on the oven activities and can be
set also when the oven is off. The time of day is displayed with
priority in any case, the
is active.
When the time expires, the
sounds a warning sequence to recall the user attention. Push
the knob to stop it.
The buzzer stops in any case after a time-out.
symbol shows the minute minder
symbol flashes and the buzzer
7 - Electronic control

3 Tone Buzzer Setting

With the cooking selector in OFF position press the +/- knob
until the "ton..." is showed, rotate the same knob count
clockwise to set the desired tone from 1 to 3 and press to
confirm.
Temperature & Time Format
Temperature unit in °F and 12h AM/PM are preset.
When the oven mode selector is in off position, push the
shuttle&push selector (TEMP & TIME) in order to select another
available format.
Turn the knob to select a different desired format, and press the
knob again to confirm.
EN
13