Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustment and calibration manual TOUCH RF remote control
A -
REMOTE CONTROL SYNCHRONISATION
1.
Connect the hood to the mains or turn ON the hood switch, optional under filters or panel.
2.
WARNING: once step 1 has been carried out, when connecting the hood to the mains power supply:
3.
After the first 5" seconds have elapsed, and within 20" seconds with the remote control facing the hood, press and
hold the LIGHT button on the remote control, and the lights on the hood will come on confirming that the process
has been successful.
If it takes more than 20 seconds to synchronise the control unit, the control unit closes the reception and will not
record any code, you must repeat the process, making sure to press the key between 5" and 20".
B -
GENERATION OF A NEW TRANSMISSION CODE (*only if necessary):
The manufacturer supplies the remote control ready for use, with the factory preset codes.
It is not necessary to change or synchronise the code, unless for reasons beyond the control unit's
control it does not work (*loss of the code due to mains variations, low battery in the control unit or
involuntary operation due to frequency interference from another user).
If you want a new generation of codes, carry out the following process:
Press and hold down the three keys in the attached drawing simultaneously,
until the blue LED on the remote control starts to flash, at this moment the
remote control is scanning through the different codes it has, when you
release the keys the LED stops flashing and records the code that was
scanning at that moment, in this way the code of the remote control is
different to the original one.
Attention, once this process has been carried out, the
control will not communicate with the hood, as the code
in the control will be different to the one previously used by
the hood. To make it work again, the control must be
synchronised, see section "A".
If you want a different code, repeat the process, and the code selected will
depend on how long you hold down the keys.
DO NOT TOUCH ANY BUTTON ON THE
CONTROL UNIT UNTIL 5" SECONDS HAVE
ELAPSED.
Logo Vectorial
(*only if necessary, it is already factory-synchronised):
Logo Tipogrà c
Pando
cooking
integral
Logo Tipogrà c
Pando
integral
cooking
Publicidad
