Sony NSBK-EB05 Manual De Instalación página 10

Caution
When using cameras and power supply
units that superimpose DC voltage on the
video coaxial cable, pay close attention to
the coaxial cable wiring. If the camera cable
on which DC voltage is superimposed is
connected to the NSR-500 series,
malfunctions may occur.
Analog
Power
cameras
supply
unit
Coaxial cable
on which DC
voltage is
superimposed
Notes
• To perform pan, tilt, and zoom, control
numbers must be configured. Be sure that
the numbers do not overlap when
multiple analog cameras are connected.
For details on configuring control
numbers, refer to the operating
instructions for the analog camera.
• For details on the pin assignment for the
RS-422/485 connector, refer to the
Installation Manual for the NSR-500
series.
10 Specifications
NSR-500
VIDEO
series
OUT
Coaxial cable
Be careful not to connect
the coaxial cable for the
analog cameras to the
NSR-500 series.
Specifications
Analog encoder board
External connector
Analog camera cable input (1)
Analog camera input cable
Video input connectors
Composite
BNC (16) (black, V1 to
V16)
1 Vp-p, 75 Ω
Audio input connectors
Pin jack (4) (white, A1 to A4)
Design and specifications are subject to
change without notice.