Sony NSBK-EB05 Manual De Instalación página 6

Preparation Steps
Step 1: Installing the Analog
Encoder Board on the NSR-500
Series (page 6)
Step 2: Connecting the Analog
Camera Input Cable and the Analog
Camera (page 8)
Step 3: Configuring Settings for the
NSR-500 Main Unit
Refer to the User's Guide (PDF) for the
NSR-500 series.
Step 4: Verifying Operation
Verify operation of connected analog
cameras and audio devices.
Installation Complete
6 Preparation Steps / Step 1: Installing the Analog Encoder Board on the NSR-500 Series
r
r
r
r
Step 1: Installing
the Analog
Encoder Board on
the NSR-500
Series
Caution
• Perform installation work in an antistatic
environment.
• Before installing the analog encoder
board, be sure to turn off and unplug the
NSR-500 and wait until the internal
temperature drops.
1
Remove the three screws (B3 × 6
(black)) on the rear panel of the
NSR-500 series and the two screws
(K3 × 5) on the side panels, and then
remove the chassis cover in the
direction of the arrow.
Chassis cover
Screw
(K3 × 5)
Screws
(B3 × 6 (black))
Screw
(K3 × 5)