Sony NSBK-EB05 Manual De Instalación página 7

2
Confirm the installation position.
Rear panel side
3
Pull the protection cover upward and
remove it.
Install the analog
encoder board here.
Step 1: Installing the Analog Encoder Board on the NSR-500 Series
4
Insert the analog encoder board with
the proper orientation.
5
Install the analog encoder board.
Make a visual check at the following
two points and confirm that the board
is firmly connected.
Make a visual check.
Caution
Incomplete and/or skewed insertion of
the board can cause improper
connection.
7