Publicidad
Idiomas disponibles
Idiomas disponibles
Welding and cutting equipment can be dangerous to both the operator and people in or near the
surrounding working area, if the equipment is not correctly operated. Equipment must only be used
under the strict and comprehensive observance of all relevant safety regulations. Read and understand
this instruction manual carefully before the installation and operation of this equipment.
1. SECURITY
THE OPERATION AND MAINTENANCE OF INVERTER WELDER EQUIPMENT CAN BE DANGEROUS AND
CAN AFFECT YOUR HEALTH
This equipment produces strong electrical and magnetic emissions that may interfere with proper
operation of pacemakers, hearing aids, and other electronic medical equipment.
Persons working near this equipment should consult a health professional to determine that so exposed
is it to risk.
To prevent possible injury, read, understand, and follow all warnings, safety precautions, and instructions
in this manual before using the equipment.
1.1. Symbols Explanation
The Symbols located at the top, mean ATTENTION, Moving parts in operation. There is risk of electric
shock, or hot parts can damage parts and/or body. By following the Indications below, it is safe enough
to operate after taking the corresponding safety measures.
- The following signs and descriptions refer to the dangers and damages that your body or others may
su er when carrying out the cutting process.
- Remember when you see these symbols that cutting without proper protection can be dangerous.
- Only properly instructed and trained personnel can install, check, operate, maintain and repair any
SWEISS equipment.
- During operation, people not directly involved in the welding process should be far enough away,
especially children.
- After stopping the power of the equipment, to carry out maintenance or to examine the equipment,
proceed according to chapter "5", since residual voltage may remain in the capacitors and / or other
electronic parts.
1.2. Electric shock
Touching live electrical parts can cause fatal shocks or severe burns. The electrode and work circuit is
electrically live whenever the output is on. The input power circuit and internal machine circuits are
also live when power is on. In Mig/Mag welding, the wire, drive rollers, wire feed housing, and all metal
parts touching the welding wire are electrically live. Incorrectly installed or improperly grounded
equipment is dangerous.
01
SWEISSWELD.COM
Publicidad
