Publicidad
Idiomas disponibles
Idiomas disponibles
3.7. TIG Welding
(1) Switch the ON/OFF Switch (located on the rear panel) to OFF.
(2) Connect the earth lead to "+", tighten clockwise;
(3) Connect the TIG torch cable to "-", tighten clockwise;
(4) Using a secured Argon cylinder, slowly crack open then close the cylinder valve while standing o
to the side of the valve. This will remove any debris that may be around the valve & regulator seat area;
(5) Install the regulator and tighten with a wrench;
(6) Connect the gas hose to the outlet of the Argon regulator, and tighten with a wrench;
(7) Be sure the gas valve on the torch is closed, and slowly open the Argon Cylinder Valve to the fully
open position;
(8) Connect the ground clamp to your work piece;
(9) Plug the power cable into the appropriate outlet.
NOTE:
When TIG operation, the shielded gas is inputted to welding gun directly.
Secure the gas cylinder in an upright position by chaining them to a stationary support to prevent
falling or tipping.
TIG torch
Work piece
17
SWEISSWELD.COM
Gas
cylinder
Publicidad
