Control Elements - Kemper MaxiFil Clean Manual De Uso

6.2

Control elements

The following controls and connections are found on the front side of the MaxiFil
Clean device:
- Device switch (pos. 1)
Press this button to turn the device on and off. A green light ring around the
power button indicates trouble-free operation of the unit, i.e. its operability
when using the Start/Stop sensor.
The green light goes out in case of failure or error.
The device switches off automatically.
- LED indicator lamp (pos. 2)
Yellow warning light indicates a device failure. These faults are visually
represented by different flashing codes.
The LED indicator lamp flashes evenly at regular intervals:
- The equipment shall undergo regular service, please inform KEMPER
service.
The LED indicator lamp flashes 2 times shortly in succession at regular
intervals:
- The motor protection relay was activated, please inform KEMPER
service.
The LED indicator lamp flashes 3 times shortly in succession at regular
intervals:
- Incorrect rotation field, the fan rotates in the wrong direction. To
correct this situation, an electrician shall swap two CEE connector
phases.
The LED indicator lamp flashes 4 times shortly in succession at regular
intervals:
- Missing or insufficient compressed air supply. Connect MaxiFil Clean
to the compressed air network at the installation area. The required
compressed air is 5 – 6 bar, clean and dry air free of oil.
The LED indicator lamp flashes 5 times shortly in succession at regular
intervals:
- The dust collection tank is missing or is filled with dust.
- Positioning regulator for the deceleration period in Start/Stop operating
mode (pos. 3)
When connecting the Start/Stop sensor (optional feature), you can adjust the
suction deceleration after the welding process has finished within the range of
5 - 60 seconds.
KEMPER MaxiFil Clean Instruction manual - EN
- 56 –
Technical changes and errors reserved.