Use; Qualification Of Operating Personnel; Control Elements - Kemper ProfiMaster Manual De Uso

6 Use

Any person who uses the ProfiMaster device, repairs it or performs its maintenance
must be made familiar with this instruction manual in detail and understand its
contents.

6.1 Qualification of operating personnel

The operator of the ProfiMaster device may only appoint individuals properly
familiarized with using this device to use the unit independently.
Becoming familiar with this device also includes training the relevant individuals
concerned by the operations, and the knowledge of this Instruction Manual or other
relevant operating instructions.
The ProfiMaster device may only be used by trained and knowledgeable staff. This is
the only way to achieve safe operation of the unit with regard to the impending
dangers.

6.2 Control elements

On the front side of the ProfiMaster device there are controls and connections:
Switch I / 0 (pos. 1)
-
Press this switch to turn the device on and off.
A green signal light in the switch control panel indicates the trouble-free
operation of the unit, i.e. its operability when using the optional Start/Stop
sensor.
LED indicator lamp (pos. 2)
-
If the yellow signal light is on, it may indicate the following failures:
- Motor protection relay has responded
- Error of the sequence of phases / missing phase
- Filter replacement is necessary
- Recessed hole for the Start/Stop terminal (pos. 3)
Recessed hole for automatic Start/Stop optional unit
- Pressure measurement opening (pos. 4)
Connection for KEMPER service.
Through this connection the KEMPER service department can perform
pressure measurements.
Product number: 150 2464
Technical changes and errors reserved.
KEMPER ProfiMaster Instruction Manual - EN
- 55 - rev.: 2
Status as of: 05/2015