Breville The Oracle Touch BES990BSS1BUS1 Manual De Instrucciones página 23

CLEAR WATER BACKFLUSH
• After each coffee making session we
recommend doing a clear water backflush
before you turn off the machine. Empty drip
tray. Insert the cleaning disc into the filter
basket then insert the portafilter into the
group head. Touch the 'Brew' button and
allow pressure to build for 20 seconds, then
touch to stop & release pressure. Repeat this
5 times to purge any fine coffee grounds and
residual coffee oils from the brew water paths.
CLEANING THE SHOWER SCREEN
• The group head interior and shower screen
should be wiped with a damp cloth to remove
any ground coffee particles.
• Periodically, run hot water through the group
head with the filter basket and portafilter in
place, but without ground coffee. This will
remove any residual ground coffee particles
from the shower screen.
• If there seems to be stubborn build up
on the shower screen, use the allen key to
undo the screw in the middle of the shower
screen, making note of which side faces into
the group head.
CLEANING THE DRIP TRAY
& STORAGE TRAY
• The drip tray should be removed, emptied
and cleaned after each use.
• Remove grill from the drip tray. Wash the drip
tray in warm soapy water.
• The storage tray can be removed and cleaned
with a soft, damp cloth (do not use abrasive
cleansers, pads or cloths which can scratch
the surface).
CLEANING THE OUTER HOUSING
& CUP WARMING TRAY
• The outer housing and cup warming tray
can be cleaned with a soft, damp cloth. Polish
with a soft, dry cloth. Do not use abrasive
cleansers, pads or cloths which can scratch
the surface.
NOTE
Do not clean any of the parts or accessories in
the dishwasher.
DESCALE
• Use this function to access the descale
procedure when promoted on screen.
• The machine will enter descale mode if you
choose to descale from the pop-up message
or if you choose 'Settings' > 'Descale Cycle'.
Follow the instruction on the touch screen.
• Please ensure you allow approximately
60 minutes to complete the entire descale
process and follow the step by step
instructions. If you've just finished using
your machine, please ensure to turn the
machine off and allow to cool for at least 1
hour before starting your descale process.
NOTE
DO NOT attempt to descale your machine
without using the Descale procedure in the
Settings menu. Damage to your machine
could occur.
23