Janome 9200D Manual De Instrucciones página 43

3
6
7
4, 5, 6, 7
8
9
8, 9, 10
42
3
4
5
10
3. Hold the thread at both ends and tug gently to
ensure the thread is correctly inserted between
the tension discs. (If the presser foot lifter is
raised, the thread easily inserts between the
tension discs.)
3
Right needle thread tension dial
4,5,6. After passing through the front cover thread
guide (1), pass the thread from the bottom of
the front cover thread guide (2) and the take-
up lever cover from right to left.
7. Guide the thread over the front cover thread
guide (3).
4
Front cover thread guide (1)
5
Front cover thread guide (2)
6
Take-up lever cover
7
Front cover thread guide (3)
8. Insert the thread into the right slot of needle
thread guide plate.
9. Raise the needle to its highest point and pass the
thread through the needle bar thread guide from
left to right.
10. Thread the right needle from front to back and
pull the thread about 10 cm (4˝) from the eye of
the needle to the back.
8
Needle thread guide
9
Needle bar thread guide
10
Right needle