Planika COMET BURNER Manual De Montaje página 15

1. Open the lid (I) and turn the device on by pressing
2. If the fuel tank is empty
pump inlet 'a' (you will hear a click sound) and the power cord 'b' (III)
If the fuel bottle is secured with the flame restrictor (cap on the bottles' neck) (V) please remove it before inserting
3.
the fuel pump inlet (VI) Place the fuel container stably on the floor and insert the pump hose 'c' (VI). Press and hold
the button on the pump to start refuelling (VII).
When the fuel bottle is empty, replace it with a full one and continue using the pump (see: section 3 above). The pump
will stop refilling when the fuel tank is full
4. Unplug the power cord 'b'. To unplug the pump, hold the pump inlet and firmly press the release button (IX).
5. Shake the remaining fuel from the hose 'c' to the container and place the pump in the bag (X).
When the appear on the display, the device is ready to be launched.
Press on display and then
10 minutes. During the process of firing up, scent of fumes can be present. When the (STARTING) stop flashing, and
the flame high level appear- the device is lit up and has reached the working temperature.
Power on
REFUELLING
(NO FUEL)
- will appear on display (II) or if you want to refuel the fireplace, firmly plug in the fuel
(DISCONNECT PUMP)
FLAME IGNITION
button. (STARTING) - will appear on display. Firing up of the device takes from 2 to
Flame on
.
(REFUELLING)
- will appear on display (IV)
- will appear on display (VIII).
Starting procedure
15
Ready to use