Publicidad
Idiomas disponibles
Idiomas disponibles
English
13. For drilling into brick <DV18DL>
CAUTION:
When the Cordlless hammer drill is used continuously, the body may be heated. If this
happens, leave the Cordlless hammer drill to cool.
Excessive pressing force never increases drilling speed. It will not only damage the
drill tip or reduce working efficiency, but could also shorten the service life of drill bit.
Operate Cordlless hammer drill within 20 – 30 lbs. (10 – 15 kg) pressing force while
drilling into brick.
THE SCOPE AND SUGGESTIONS FOR USES
Work
Brick
Wood
Drilling
Steel
Aluminum
Small
screw
Screw
tightening
Wood
screw
Work
Wood
Drilling
Steel
Aluminum
Small
screw
Screw
tightening
Wood
screw
CAUTION:
While operating the Cordless hammer drill, take care not to lock the motor.
If the motor is locked, immediately turn the power off.
If the motor is locked for a while, the motor or battery will be burnt.
Do not tighten too strongly as the screw heads will be damaged.
To extend the lifetime, the lithium-ion battery equips with the protection function to
stop the output. Therefore, when used as a drill, if the tool is overloaded, the motor
may stop. However, this is not the trouble but the result of protection function. In this
case, release the switch of tool and eliminate the causes of overloading.
24
Table 4 <DV18DL>
Cap position
Use for drilling purpose.
Use for drilling purpose.
Use the bit and socket matching the screw
1 – 22
diameter.
1 –
Use after drilling a pilot hole.
Table 5 <DS18DL>
Cap position
Use for drilling purpose.
Use the bit and socket matching the screw
1 – 22
diameter.
1 –
Use after drilling a pilot hole.
Suggestions
Suggestions
Publicidad
