Publicidad
Idiomas disponibles
Idiomas disponibles
temperature
thinning,
if Poulan
or Poulan
PRO
bar and chain oil is not available,
use a
good grade SAE 30 oil,
• Never
use
waste
oil for
bar and chain
lubrication,
• Always
stop the engine
before
removing
the oil cap,
IMPORTANT
Experience
indicates
that
alcohol
blended
fuels
(called
gasohol
or using
ethanol
or
methanol)
can attract moisture which leads to
separation
and formation of acids during stor-
age, Acidic gas can damage
the fuel system
of an engine while in storage.
To avoid engine
problems,
empty the fuel system before stor-
age for 30 days or longer, Drain the gas tank,
start the engine and let it run until the fuet lines
and carburetor
are empty, Use fresh fuel next
season.
Never
use
engine
or carburetor
cleaner products
in the fuel tank or permanent
damage
may occur,
See the STORAGE
section for additional
in-
formation,
HOW
TO STOP
YOUR
UNIT
• To stop the
engine,
move
the
ON/OFF
switch to the OFF position.
• If engine does not stop, move choke lever
to the FULL CHOKE
ON/OFF
Switch
HOW
TO START
YOUR
UNIT
_
WARNING:
Make sure the chain will
not make contact
with any object while start-
ing the engine, Never try to start the unit when
the guide bar is h_ a cut,
Avoid any contact
with the muffler. A hot muffler can cause seri-
ous
burns.
HELPFUL
!f your engine still does not
I
Pstart
after
foflowing
these
I
instructions,
pleas e
Carl
1-800-554-5723.
STARTING
A COLD
ENGINE
(or a
warm
engine
after
running
out
of
fuel)
;___:,L_;_>'7_
tartlng Position
Primer Bulb
Choke
Lever
Muffler
1.
Set unit on a flat surface,
2.
Move ON/OFF
switch to the ON position,
3.
Slowly press the primer butb 6 times.
4.
Move
choke lever to FULL
CHOKE
by
aligning lever with position
shown on de-
cal (see illustration
below),
5.
Squeeze
the throttle trigger fully and hold
through aft remaining steps.
6.
Pull starter rope handle sharply
until en-
gine sounds as if it is trying to start, but do
not pull rope more than 6 times.
7.
As soon as engine sounds as if it is trying
to start,
move
choke
lever
to HALF
CHOKE
by aligning
lever with position
shown on decal
Choke
position
decal
11
8.
Pull starter rope sharply until engine runs,
but no more than
6 pulls, If the engine
doesn't
start after 6 pulls (at the HALF
CHOKE position), move the choke lever to
the FULL CHOKE position and press the
primer bulb 6 times, Squeeze and hold the
throttle trigger and pull the starter rope 2
more times. Move the choke lever to the
HALF CHOKE position and pull the starter
rope until the engine runs, but no more than
6 pulls, if the engine doesn't start, repeat
procedure 2 additional times.
NOTE:
If
engine
still doesn't
start,
it is probably
flooded.
Proceed
to
STARTING
A
FLOODED
ENGINE.
9.
Once the engine starts, altow it to run 10 se-
conds, then move the choke lever to OFF
CHOKE
by aligning
lever with position
shown on decal (see illustration below). Al-
low the unit to run for 30 more seconds at
OFF CHOKE
before releasing the throttle
trigger.
Publicidad
