Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Ifengine
dies with t he choke lever
inthe OFF CHOKE
position,
move the
choke lever tothe HALF CHOKE
position
Coupler
and pull the rope until engine
runs, but no
more than 6 pulls.
Lower
Attachment
Upper Shaft
Choke
position
decal
STARTING
A WARM
ENGINE
1.
Move ON/OFF
switch to the ON position.
2.
Move
the
choke
lever
to the
HALF
CHOKE
position.
3.
Squeeze
and
hold the throttle
trigger.
Keep throttle trigger fully squeezed
until
the engine runs smoothly.
4.
Pull starter ropesharply
until engine runs,
but no more than 5 pulls.
5.
Allow
engine
to run 15 seconds,
then
move the choke lever to the OFF CHOKE
position.
NOTE:
If engine has not started, pull starter
rope 5 more pulls. If engine still does not run, it
is probably flooded.
STARTING
A FLOODED
ENGINE
Flooded
engines
can be started
by p_acing
the choke lever in the OFF CHOKE
position;
then. pull the rope to clear the engine of ex-
cess fuel. This could require pulling the starter
handle many times depending
on how badly
the unit is flooded.
If
the
unit
still
doesn't
start,
refer
to
TROUBLESHOOTING
TABLE
or
call
1-800-554-6723.
OPERATING
THE
COUPLER
This model is equipped
with a coupler
which
enables
optional attachments
to be installed.
The optional attachments
are:
MODEL:
Edger .......................
PP10OOE
Cultivator
....................
PP2000T
Blower
......................
PP3000B
Brushcutter
..................
PP4000C
_WAR
NIN G:
Always stop unit and dis-
connect
spark plug before removing
or instal-
ling attachments.
REMOVING
PRUNER
ATTACH-
MENT,
LINE
TRIMMER
ATTACH-
MENT,
OR OTHER
OPTIONAL
AT-
TACHMENTS
CAUTION:
When removh_g or installing at-
tachments,
place the unit on a flat surface
for
stability.
1.
Loosen
the coupler
by turning
the knob
counterclockwise.
TIGHTEN
Knob
Press and hold the locking/release
button.
Locking/Release
Button
cup er _
Upper Shaft
Lower Attachment
3.
While securely
holding
the engine
and
upper shaft, pull the attachment
straight
out of the coupler.
INSTALLING
OPTIONAL
ATTACH-
MENTS
1.
Remove
the shaft cap from the attach-
ment (if present).
2.
Position locking/release
button of attach-
ment into guide recess
of coupler.
3.
Push the attachment
into the coupler
until
the locking/release
button snaps into the
primary hole.
4.
Before using the unit, tighten the knob se-
curely by turning clockwise.
Coupler
Primary
Hole
Guide Recess
Upper
Locking/
Attachment
Shaft
Release
Button
w_WARNING:
Make sure the locking/
release
button
is locked
in the primary hole
and the knob is securely
tightened
before op-
erating
the unit. All attachments
are designed
to be used in the primary hole unless otherwise
stated in the applicable attachment
instruction
manual Using the wrong hole could lead to seri-
ous injury or damage to the unit.
Secondary
Hole
Locking/Release
Button in Primary
Hole
12
Publicidad
