Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
This power tool generates an electromagnetic field
during operation. This field can impair active or pas-
sive medical implants under certain circumstances. In
order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the power tool.
WARNING
In case of extended working periods, the operating
personnel may suffer circulatory disturbances in their
hands (vibration white finger) due to vibrations.
Raynaud's syndrome is a vascular disease that caus-
es the small blood vessels on the fingers and toes to
cramp in spasms. The affected areas are no longer
supplied with sufficient blood and therefore appear
extremely pale. The frequent use of vibrating prod-
ucts can cause nerve damage in people whose circu-
lation is impaired (e.g. smokers, diabetics).
If you notice unusual adverse effects, stop working
immediately and seek medical advice.
WARNING
Follow the safety instructions and the
notes regarding charging and correct use,
as specified in the operating manual for
your 20V gomag series battery and battery
charger. A detailed description of the
charging process and further information
are provided in this separate manual.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
6
Technical data
Cordless snow blower
Motor voltage
Protection category
Protection class
Idle speed min. – max.
Roller width
Clearing width
Max. snow height
Max. ejection width
Weight (without battery)
24 | GB
Temperature
• Operation
• Storage
Subject to technical changes!
Noise and vibration
Noise can have serious effects on your health. If the
machine noise exceeds 85 dB, please wear suitable
hearing protection for you and persons in the vicinity.
The noise and vibration values have been determined
in accordance with EN ISO 8437-4.
Noise data
Measured sound pressure L
Measurement uncertainty K
Measured sound power
Measurement uncertainty K
Guaranteed sound pressure
Vibration parameters
Vibration on the bar a
Measurement uncertainty K
The total vibration emission values specified and the
device emissions values specified have been measured
in accordance with a standardised test procedure and
can be used for comparison of one electric tool with an-
other.
The total noise emission values specified and the total
vibration emission values specified can also be used for
an initial estimation of the load.
The noise emission values and vibration
emission value can vary from the specified
values during the actual use of the power
tool, depending on the type and the manner
in which the electric tool is used, and in
particular the type of workpiece being pro-
cessed.
GO-SNF400
Try to keep the stress as low as possible. For exam-
40 V
ple: Limit working time. In doing so, all parts of the
IPX1
operating cycle must be taken into account (such as
times in which the power tool is switched off or times
III
in which it is switched on, but is not running under a
1667 – 1998 rpm
load).
34 cm
40 cm
20 cm
6 m
6.5 kg
www.scheppach.com
WARNING
pA
pA
LwA
wA
h
WARNING
max. 50°C
-20 – 50°C
5 – 30°C
78.6 dB
3 dB
89.85 dB
3 dB
92 dB
2
0.812 m/s
2
1.5 m/s
Publicidad
