Publicidad
Idiomas disponibles
Idiomas disponibles
7
Unpacking
WARNING
The product and the packaging material are not
children's toys!
Do not let children play with plastic bags, films or
small parts! There is a danger of choking or suf-
focating!
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. Immediately report any damage to the
transport company that delivered the Product. Later
claims will not be recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the prod-
uct.
8
Before commissioning
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
8.1
Fitting the bar (Fig. 1 - 5)
Note:
There is a cable inside the bar. Do not crush or stretch
the cable.
1. Push the lower bar (9) into the upper bar (5).
2. Insert the M6 carriage bolt (8) into the square re-
ceptacle on the upper bar (5). Screw the wing nuts
(7) onto the M6 carriage bolt (8).
3. Press the spring ball (11) and keep the spring ball
(11) pressed. Push the bar (5 + 9) into the bar
mount (12). The spring ball (11) engages in the hole
provided.
4. Guide the M6 hexagonal bolt (10) into the bolt
mount on the bar mount (12). Screw the wing nuts
(item 7) onto the M6 hexagonal bolt (10).
8.2
Adjusting the guide handle (Fig. 1
+ 6)
Note:
In order to be able to work with the product, the guide
handle must be in line with the handle.
1. Open the wing nuts (7).
2. Turn the guide handle (6) until it is in line with the
handle (1). Push the guide handle (6) to a working
height that you find comfortable.
3. Close the wing nuts (7).
9
Operation
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
9.1
Inserting/removing the batteries
(21) into/from the battery mount
(Fig. 7)
Inserting the batteries
1. Open the cover (20).
2. Push the two batteries (21) into the battery mount.
The batteries (21) click into place audibly.
Removing the batteries
1. Press the battery release button (22) and pull the
batteries (21) out of the battery mount.
9.2
Adjusting the ejection direction
(Fig. 9)
ATTENTION
The lever may only be actuated when idle.
Note:
Positions: Left = -30°, centre = 0°, right = +30°
1. Wait until the product has come to a standstill.
2. Pull the lever (14) upwards and turn the lever (14)
into the required position. The snow guidance fins
(17) rotate in the ejection direction.
3. Release the lever (14).
www.scheppach.com
GB | 25
Publicidad
